ANYCUBIC CHIRON FULL GUIES (optional install precision piezo)

CHIRON FULL LINEAL GUIDE

Update: the option to install a 27mm precision piezo sensor is added. To do this, replace the piece called REAR_REINFORCEMENT.obj, with the two pieces named as piezo refuerzo carro piezo A and B.

Update 2, drawing for laser cutting of the 5mm aluminum bed support is added. It is to mount linear guides.

Thanks to @Rad088

Make this modification at your own risk!

Please note that the X axis is limited to 370mm. (outer lines of the square drawn on the bed)

It also loses a little on the Z axis, I have not measured how much ...

Linear guides in Y:

Thanks to the fantastic work of Nadeon: https://www.thingiverse.com/thing:3682048

Necessary material:

(It did not include the necessary material for the guides in the Y axis)

1u, Guide MGN12C 500mm. (with short carriage) for X axis

2u. Guide MGN12H 550mm. (with long carriage) for Z axes

1u. Radial fan 5015

1u. mellow bmg metal extruder

1u. fan (extruder) i currently use a 4020

2m .. GT2 6MM strap (I have used approximately 1.3m)

1u. 20T pulley

Screw Assortment M3-A2 http://s.click.aliexpress.com/e/WLDwXVQ

Tnuts M3 (at least 12u. Not counting those needed for the Y axis)

2u M3x50mm screws (may be a little shorter, they are for the X axis tensioner)

1u. countersunk screw M3x20 (pulley fixing)

4u. M3X45 screws for extruder motor

Nuts M3 (I think I have counted at least 12u. But I recommend that you have some more on hand ...)

long hex nut M3x60 or 2u. 30mm) (they are for the chain carrier support)

M5 bolts and nuts are reused as well as existing limit switch stops.

Surely leave me a screw to name ... have a good assortment on hand just in case.

The end of X's career is behind the car.

To print:

2 x SEPARATOR Z

2 x ELEVATOR END STOP

The rest 1 unit.

I recommend changing the extrusion fan for a bigger one.

Printed with PETG with at least 50% filler, gyroid filler

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

50

Filament: ERYONE PETG RED CARAMEL