Hans

@Hans_193091

A small, decorative Christmas light. Illuminated by a simple led tea light.

354

1648

7716

updated November 13, 2022

Suzukiracing250

@Suzukiracing25_40754

Great design! Easy to print and looks great.

T 10

Troldrik

@Troldrik_113214

Printed in Polymaker HT-PLA White for the base, and Fillamentum Crystal Clear PLA for the tree. Scaled a few percent to fit my 40mm rechargeable lights. (edited)

PrintingDad

@PrintingDad_2478094

Printed great, I used transparent PLA.

Spiral Architect

@SteveGotthardt

Red petg
.5 nozzle .25 layer

Denna

@Denna_1862740

I really like this tree. I printed it with a white base and transparent yellow PETG.
For the base I added a negative cylinder of 30mm diameter to create the hole for the light switch. As others already mentioned, this is much more convenient.

Dmitry Ermakov

@DmitryErmakov_410542

Nice! Cool! I like it!

R 14

Rudi29

@Rudi29_287102

It's so nice that I have already made two more.

Iridium

@Iridium

Beautiful Christmas decoration. Amazing.

Lemm

@Lemm

very nice design. I like the look of the vase mode. (edited)

Freethink

@Freethink

I wish it had a hole in the bottom to switch the light on and off. So cool!

jakeypoo2008

@jakeypoo2008_1424460

@Freethink how can you put a Christmas on base with led candle light

Freethink

@Freethink

@jakeypoo2008_1424460 I normally use Cura, and if you print the model in vase mode with 0 bottom layers it prints hollow. But the model should have a lip to attach magnets to, so i had to use prusaslicer in vase mode to correctly print the tree hollow with the magnet lip.