I found these wonderful handles by DaVinci2000 at https://www.printables.com/model/243849-drill-bit-handle-15-6-mm which work perfectly for my old set of needle files. As the original plastic container for the needle file is deteriorating I decided to make a rack for them that would accommodate all of the files plus three of the DaVinci2000 handles.
Version 3 has a second axis of alignment pin on the top of the central support shaft because I found, much to my annoyance that it was possible to glue the top plate on 180 degrees out on the wrong orientation so the holes would not line up. Version 3 fixes that issue!
No supports or brim needed. Easy no stress print.
The author marked this model as their own original creation.