Carriage Adapter Plate for 3D Printed Linear slide

This is an adapter plate I made to allow a the Kossel Mini's delta arm carriage to be mounted to jcrochol's printed 3d Linear Slide that KongorillaSJK scaled for Misumi 2020 (https://github.com/kongorillaSJK/recirculating). Note: this is NOT for the carriage_recirculating part, this is the standard carriage part from the Kossel repo!)

Instructions

This uses M3 screws. For the slide plate to adapter, use very short screws (I think 8mm should be ok - I will update when I have confirmed), or cut any excess sticking out of the adapter plate so it is flush with the side of the plate that mates with the carriage.

For mounting the carriage to the adapter plate, there are 4 captured nut cavities. I may revise these to accomodate nyloc nuts, but for now standard M3 Nuts. Use 12mm or 14mm screws for the upper mounting and 8 or 10mm for the lower mounting holes.