Apple Watch Ultra Stand

I modeled this to be similar to the stand I have but I allowed it more space for the size of the Apple Watch Ultra. Since the lip that holds the bottom of the watch was slightly too high and didn't allow the Ultra to fully seat into the magnet so it would easily disconnect.

This should still work for any Apple Watch Size and any Series. (Watch might not touch the front lip)

I left the front of the stand flat so that you're able to add in your own logo or words as you wish. Hole in the back is for easily removing the puck, press with your finger and it will pop out. Cable is routed through the hole. This allows you to remove the cable if the stand is stuck down to your table.

________________________________________________

2 VERSIONS:

• Apple Watch Ultra Stand - Metal Charger: This one is for the metal charging puck. It's slightly thinner (6.35 mm) than the regular plastic charger (7.62 mm). Wire on top.
• Apple Watch Ultra Stand - Plastic Charger: This one has the added thickness accounted for. The puck should be flush with the stand. Wire on top.

These versions have the cable routed on top. This will not hide the wire but if you use double sided tape to stick it on the surface, you will be able to remove the wire really easily for travel.

If you use the Metal Charger STL for the plastic puck, it will stick out slightly.

EDIT (Feb 18, 2023): 2 ALTERNATIVE VERSIONS

• Apple Watch Ultra Stand - Under - Metal Charger: This one is for the metal charging puck. It's slightly thinner (6.35 mm) than the regular plastic charger (7.62 mm). Wire underneath.
• Apple Watch Ultra Stand - Under - Plastic Charger: This one has the added thickness accounted for. The puck should be flush with the stand. Wire underneath.

These versions have the cable routed underneath. This will hide the wire but if you use double sided tape to stick it on the surface, you will not be able to remove the wire as easily.

If you use the Metal Charger STL for the plastic puck, it will stick out slightly.

________________________________________________

Please if you have any issues, let me know and I can make modification if need be.

See Print Settings Notes for further printing details.

________________________________________________

Print Settings

Printer:

Creality Ender 3 S1 Pro

Rafts: 

No

Supports:

Yes (Depends machine, 

Resolution: 

0.2

Infill:

20%
 

Notes:

My test print was set to 10% infill (to test) and seems pretty solid. Would have probably done it in 15%-20% to add a bit more weight. I attached it to my bedside table with 3M double sided tape so it will not move around either way. Print at higher infill for a more solid, heavier base (can set settings to print bottom at higher infill and less towards the top)

I printed with "Tree" supports, the hole at the bottom of model is to allow for the supports to print at a better location. This makes sure no supports touch the final product and directly support the hole for the charging puck. (Also cuts down on materials)

I made it out of PLA (all I have as I'm new to all this). Something softer like TPU may be better. Cannot test.

TIME TO PRINT: 3-5 hours depending on settings.

Charging Puck will fit snuggly in its slot. If it does not fit, use high grit sandpaper and sand down the inner edge. There are little nubs in there to help ensure a very snug fit. It will have a very satisfying click when it's inserted.

Category: Gadgets