EVOC magnetic tube clip

I managed to snap off the clip from the original tube clip I bought even before I got it out of the cardboard packaging!

You can “peel” off the remaining plastics around the magnet (with side cutters) and then place the magnet inside this printed replacement part.

Print instructions:

1. This part is super critical on the print orientation because of the clip geometry!
2. See picture f at least one working print orientation.
3. Layer height of 0.1 mm and 100 % infill produces sturdy part. Have not tested any other settings.

Build instructions:

1. Note that the original EVOC magnet shape is NOT symmetrical like a coin.
2. Flat face of the magnet is same side as the clip.
3. Push in the magnet from the opening at the side.
4. No glue, no nothing needed.

Enjoy!