Needed to fill the holes in the cruiser left over from the previous owner not installing switches correctly etc.
I tried to make it match the curved surface, however that was too hard to print so decided on a flat plate.
Use this as a basis for creating holes in the center to install switches and leds etc.
Printed in both ABS and pla, both work without an issue
Printer:
FLSun Kossel Mini
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
25%
Category: AutomotiveThe author marked this model as their own original creation. Imported from Thingiverse.