DELTA PIPE PRINTER - STEP 7 - IDLER END

DELTA PIPE PRINTER (DPP) Please see the DELTA PIPE PRINTER STEP 1 TOP FRAME for more references and instructions…
0
4
0
159
updated October 13, 2022

Description

PDF

DELTA PIPE PRINTER (DPP)

Please see the DELTA PIPE PRINTER STEP 1 TOP FRAME for more references and instructions http://www.thingiverse.com/thing:1344167

Custom Section

INTRODUCTIONS

This idler end fit directly into the pipe. The location is at 1 inch from the top of the tour pipe.

It contain 2 (5 x 11 x 5mm F685zz Shielded Flanged Ball Flange Bearing) and one 25mm M5 screw and one M5 washer.

Here where I buy my ball bearing: https://www.aliexpress.com/item/5-x-11-x-5mm-F685zz-Shielded-Flanged-Ball-Flange-Bearing/2031713724.html?spm=2114.13010608.0.0.72fWs6

The end stop will also screw on the back side of the idler end using 2 x 10mm M3 screws and 2 M3 nuts. I used NYLON but I guess metal will not give issue with the electronic but I take no change :).

endstop with 2 x 10mm M3 screws and 2 M3 nuts (nylon)

PRINTING

Use the IDLE END STL

I used 20% infill.

You need this piece 3 times...

Here what it look when installed in a pipe, they go on the tour, but the tour STEP is not yet done. It will be updated shortly... Please note I used a scrap pipe to show the result.

The M5 screw screw directly into the plastic no need to have a nut. The washer is outside where the head screw is, the 2 bearing are in the middle of the plastic.

Category: 3D Printers

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License