Ikea PLATSA spool holder V2

A simple spool holder to fit the Ikea PLATSA closet.

My previous design had a filament guide to it, but for the sake of reusability and flexibility, I found it better to make that into a separate part.

Spool requirements:
Minimal inner diameter: 50mm
Maximum spool-width: 80mm

Verified to fit the following spools (but obviously not limited to, I'm yet to get a spool that doesn't fit):

• Prusament (1kg)
• PrimaCreator (1kg)
• ColorFabb (750g)
• Azurefilm (1kg)
• Esun (1kg)
• Sunlu (500g)
• HobbyKing (1kg)
• Anycubic (1kg)
• 123-3D (1kg)
• Real Filament (500g / 1kg)
• Eryone (1kg)

If this helps you out, please like, rate and/or share a picture of the result! Otherwise, please leave a comment with feedback 😉
 
 

Changelog

• 10 dec 2020
  • Removed spool-holder.stl
  • Added spool-holder-preoriented.stl (same stl as before, but oriented in a way that no orientation change is needed when opening in PrusaSlicer)
  • Added spool-holder.3mf (print profile + stl)
  • Added gcode for MK3S

Print instructions

[email protected] layer height, 15%+ infill, with 3 perimeters. Orientation as pictured.