Simple fold-down doorstop. Designed to fit 1" round foam grippers I found at the hardware store. I didn't want to put screw holes in my door (this was designed for light interior doors) so it's mounted with an adhesive foam mounting strip. The one pictured was intended to just be a test, hence some rough edges, but it worked so well that I decided to keep it up.
In addition to printing one of each part, you will need some simple hardware:
1x machine screw, 3.75mm (1/8in) diameter & at least 42mm (about 1 5/8in) length
1x nut that fits the screw
2x washers, 9mm (~3/8in) diameter
You could probably make due without the washers, but I find that it's always a good idea to put washers under both the head and nut of any bolt being used for 3D printing.
Printer:
Wanhao Duplicator i3
Rafts:
Doesn't Matter
Supports:
Yes
Notes:
Could be printed without supports with the right orientation but I recommend putting both objects on their side for maximum strength in the directions that matter (see screenshot for details).
Category: HouseholdThe author marked this model as their own original creation. Imported from Thingiverse.