I needed a tray to keep the 3d printed spinners falling off the table. I created the large version (diameter: 135 mm , edge 6mm) and a small version (diameter: 70mm edge 6mm ) .
Ideally should be printed with silk PLA to keep the surface smooth.
I also increased the top layer count to 3 to keep the top sturdy with minimum infill
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
10%
Filament:
misc PLA Silk
Notes:
If you opt for lower infill, recommend to increase the top layer count to 3 to keep the top sturdy when the spinner spins
Category: Toy & Game AccessoriesThe author marked this model as their own original creation. Imported from Thingiverse.