Voron V0 V0.1 V0.2 First Layer Calibration

Used to test and adjust my coreXY RigidBot with the MadMax toolhead.

the ol kraft cheese single. 4076

Perfect for z offset calibration

Printed on V0.4006

V0.3943 here
Achived a perfect first layer.

Great to get that first layer just right! Can easily tell which screw needs adjusting. Thanks for sharing your design!

Great model to help get the first layer dialed in!

10/10 - perfect print for checking the Z-offset and that the bed is calibrated level.

Thank you!

I've been using Ellis' first layer squish squares on a v2.4 and found them really helpful for figuring out z offset. I'd looked at the large square and thought... nope! Then I was really struggling with the small squares on the v0 because of the size of the bed. I couldn't get the adjustment right before all the squares were finished. So I just tried this and it was perfect. I also found out why I was struggling so much. I had to shift Z up significantly more than expected. Hopefully now I've got something repeatable. Thanks for helping remove the stress of getting on with printing!

Voron 0.2411 probably the third time I've leveled this since finishing assembly in February. Filament shown is Jessie PLA Green Slime Glitter

Very Useful! I had to do a filament swap towards the end of this run, so there's a bit of a gap in the back left, but that's not the model's fault.