3 Taco Holder
I have only printed this once and it turned out ok. It was a bit shaky at the top before the two bars meet at the top.…
19
141
0
807
updated
October 12, 2022
Description
PDFI have only printed this once and it turned out ok. It was a bit shaky at the top before the two bars meet at the top. Next time I will have supports for the upper third and 50-100% infill. The base started to curl up, about 1.5mm at each end. Will try a small skirt next time.
Category: Kitchen & DiningTags
Model origin
The author marked this model as their own original creation. Imported from Thingiverse.
