Protective case for JOY-IT USB Tester UM25C

A simple snap-fit case for cool usb tester from JOY-IT.

Buttons are integrated with the case - no small parts, no complicated assembly.

Just print the parts, remove the tiny supports (already included in model, dont use supports in slicer software) under the buttons using sharp knife. 

After printing, insert the usb tester in case carefully - big USB connector first, then gently push on the back. Watch out for the tiny buttons - I have prepared holes for them to slide in, but depending on printer tolerances it might colide, so dont use much force otherwise they might snap.

Once the usb tester is inside, just put the lid on top until it snaps into position. 

When printing the sleeve, orient it vertically on the build plate - and consider using some brimm. 

This isn't a remix, but my design was influenced by the amazing USB Volt Meter / USB Multimeter Case