Tenlog TL-D3 pro Voron Afterburner adapter

Print on back, supports if you need them.

I did not make any brackets to mount the circuit board, I threw all the Tenlog electronics away and use can-bus.

I printed it on the quick with a 1.0mm nozzle and it worked fine. 

Remove the big heavy aluminum stuff, this mounts to the rail slider through the black belt holder bracket.

I cheated a little bit on the picture, I didnt take one of the bracket installed. So the print head will stick out a little further with this bracket, but not much, and you probably need to change nozzle position settings. 

All the files should be the same, just different formats.