1:12 Scale Wine Bottle

I designed this in tinkercad. It is a simple 1:12 scale wine bottle for use decorating dolls houses.

These can be tricky to print. It is best to print in large ish batches or the necks will not have time to cool between layers. You should also print them with a brim to stop the falling over.

Slow the print down either for the whole print or just when it gets to the neck of the bottles.

You can then add a printed label and paint the top red/ gold etc for a nice effect.

I printed dozens of these to fill out a wine cellar in a dolls house.

The crate picture is also one of my models.

You will get a bit of stringing. Just clean it off with a blast from a heat gun or a lighter.