Drive-Thru Capsule

Modeled for use in the drive-thru at Walgreens.

Use 2 ss cs per drivethru qd.

Align print so that the flat sides face the build plate. The top half has threading for attaching to the bottom, so area around the threading will need supports (carefully remove supports from the outside to the inside to avoid snapping the threading portion off). The bottom half has a cone shape at the top of the threading so that it will not need supports.

Requires 2x 3/8 inch nuts to fit the existing threading in the store's fixture. Line up nuts on a bolt before gluing into the bottom of the capsule for a continuous thread (nuts and bolt can be found at your local hardware store, i found mine at Ace's).

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

Rafts:

No

Supports:

Yes

Infill:

40%, cubic

Filament:

Notes:

Align print so that the flat sides face the build plate. The top half has threading for attaching to the bottom, so area around the threading will need supports (carefully remove supports from the outside to the inside to avoid snapping the threading portion off). The bottom half has a cone shape at the top of the threading so that it will not need supports.

Requires 2x 3/8 inch nuts to fit the existing threading in the store's fixture. Line up nuts on a bolt before gluing into the bottom of the capsule for a continuous thread (nuts and bolt can be found at your local hardware store, i found mine at Ace's).