Flash Softbox Vase Mode

This light diffuser fits on a Godox v860II flashlight.
It's very easy to use and prints in vase mode.

If you don't have the same flashlight, you can use the provided Fusion 360 file and replace the profile of your gear. 
It doesn't need to bee very accurate since the thin walled shape is flexible. A rubber band will help to hold the softbox in place.

The extrusion width is best set to 0.8 mm.
Layer height of 0.3 mm. 
Prints fine with white PLA. I wouldn't recommend transparent filament, since it's too close to the light source and the diffusion won't be enough.