Hedgehog Flower Pot 200% scale

Original .STL on Thingiverse by A_Sterling. Enlarged 200% for my wife as an Easter gift. This was the very first overnight print on my i3 MK3s kit, and it came out beautifully in gold generic PLA. It was a very good test for rapid Y-axis travel, and I generated 33 Y-crashes during the print.

Print instructions

Gold generic PLA
Standard heat settings for PLA (210c/60c)
10% gyroid infill
200% scaled up from original
Normal mode (not stealth) - 12h37min print
0.10 'detail' mode selected
PrusaSlicer 2.0

Experienced multiple Y-axis crashes during this print. Suspect the rapid Y travel for the spines on this model are a good test for Y-axis agility.