Raspberry Pi 4 - OctoPrint Prusa Raised Mount (MK3/MK3S)

Snaps on to Malolo's screw-less/snap fit case, screws to MK3 frame, but raises it up about an inch so that there is a bit more room for plugging in USB and ethernet cables.

Other remixes I found (and printed) were a bit flimsy. I also didn't want to raise it the whole way to the top of the frame because that interfered with my light bar mount from In3DSpace.

I'm including the STL of just the mount so that you can attach it to whatever patterned snap back that you want (then use Slicer to “add a part”). You can find housing tops from Haz1 and Malolo.

UPDATE: I added a second file that raises it up 1.75" and uses 3 screws. It will still clear the light bar clips, but gives your cables even more space.