Anycubic Kobra 5015 Dual Sided Fan Duct

This is a REMIX from both BillyAlt and wjwdesign on TV here:

https://www.thingiverse.com/thing:5547902

There are 2 Versions:

Lightweight and Full plate

Printed In PETG @ 230/80 

3 walls 4 top and bottom

.6 nozzle = .24 LH / .8 LW 25% Infill

.4 nozzle = .2 LH / .6 LW

Tree supports needed - Touching Buildplate only. You don’t want supports in your ducts. 
 

Preview the slice before printing.

Remixed upgrades:

• Vents angled for better direct cooling material
• Weight reduction 30-33g in PETG

Reminder to do a PID tune with the new cooling system as this will affect your prints.

https://teachingtechyt.github.io/calibration.html#pid

Fan Used (Variable Speed) : Model: Sunon MF50152VX-1L02C-A99

Hardware Needed:

1 - 25mm M3 Screw and nut

2 - 8mm M3 Screws to replace the 2 OEM short ones

Please check level with nozzle after install. If the duct is too high or low, loosen the screws on the mount and adjust and tighten. Using washers is not a bad idea, but not necessary.  

See Pics for Wiring & Screw locations 

Please post Makes and Donate if your able. I do this for the love of the community, but any contributions are greatly appreciated.