Playmat Tube Stripes (Vase Mode)

Updated October 9th 2022

The parts printed in vase mode can be connected together to form a screw top or snap top tube. The screw top version used one Base, one Center, one Top, and one Cap to create a tube 38.5cm (15 inches) long. The Snap top version uses two Bases and one Center_V2 this version is 38.0cm long. Either version can be made longer adding an extra Centers section, each one will extend the tube by 12.5cm (4.9 inches).

These parts are interchangeable with my other play-mat tube designs Spots and Spiral

Note:

This model was designed to be printed using a .4mm diameter nozzle. Using any other size will prevent the parts from fitting together.