Bambu Lab X1C P1P P1S Filapoop scoop base insert | Plastic ramp for debris removal | NEW v3 update!

A simple print. A curved lip for the front of your X1C, P1S or P1P. Makes it easier to scoop out bits of plastic.
2,181
18 k
280
46 k
updated September 15, 2023

Makes

Comments

It does fit on the build plate when placed diagonally, so i decided to print it in one piece with support for the hooks (used PETG). Unfortunately the hooks are a bit fragile and broke off when removing the support. Luckily its a tight fit, so it stays in place either way.
Would definitely print in the intended orientation if i ever make this again.

Work as intended, very helpful.
Printed it in asa for good measure, without top and bottom and also without infill, glued the two parts with acetone.

Good assembly fit,
I sanded the ends slightly to stop it from bending up from the floor

Fits great! Printed in PETG.

Part hovers ever so slightly above the base, causing things to occasionally get stuck underneath

Muss es leider nochmal drucken, da es beim einsetzten direkt gerissen ist

Nice clean print. Perfect fit. Printed with Bambu Lab Basic PETg grey. I Chose it for the additional heat resist compared to PLA.

Did make a small modification to the infill of the large part. I set infill to 0 and used a modifier at the top section only to do infill there for the closing layers. Worked perfectly.

Works Just as expected. Thanks!