FGC68-MKII UNW370 SLIM shroud for your magfed paintball marker

this is the shroud set is based on the FGC-9 MKII shroud models. but these are modded to accept paintball barrels. in this collection is a set of different shrouds. in STL and STEP format, so you can customise the look of your marker.

to complete this build do you need to use the FGC-68 set and part of the FGC-9 and parts of the Tippmann Tipx marker

the starter set for the FGC68 can be found here:

https://www.printables.com/model/87803-fgc-68-base-package-starter-set-for-tipx-tcr-magfe

MKII upper TOP rail version (normal MKII version)

https://www.printables.com/model/87752-fgc-68-mkii-upper-set

the MKII low rail uppers can be found here:
https://www.printables.com/model/177737-fgc-68-mkii-low-rail-upper-set

this low rail right is the same hight as for the new FGC9/FGC6 MKI/MKII rails that I have made.

the FGC68 MKI low rail was in a different hight.

for now the low rail shrouds are a bit limited in there options. but this will chance later in this year. for both the FGC68, FGC6 and FGC9

in case you don’t want to wait of manual update a already printed shroud just fallow the steps in this video.
https://www.youtube.com/watch?v=480iDroe8h0
https://www.printables.com/model/176422-unw-fgc9-fgc6-fgc68-mkii-diy-low-rail-on-unw-shrou

materials needed:
for the front of the shroud
1x M3 bolt 20mm long or up to 26mm

for on the top rail
4x M3 bolt 20mm long