Gridfinity 3x3 Desktop Parametric Cup/Mug Holder
Parametric Cup/Mug holder for the gridfinity system designed to sit in a desktop organizer.
Features:
- Cup Holder
- Mug handle guide (optional)
- Drip Tray
- Througholes for easier rigid and accessory mounting
- Angled guides to ease angling of mug handles
Note:
The defaults are tuned for a “”standard"" american coffee mug. If your mug is <85 mm in diameter, has a <10deg taper and the handle is more than 10mm off the ground it should fit pretty well assuming the diameter isn't too much smaller than 85mm.
This is intended for painters. I'm sure you could use it as a mug holder for coffee, but I'm not responsible if you scald yourself from a melted cupholder. Use a high temp filament if going this route.
License is inherited from upstream gridfinity project
TODO:
- Switch to using a profile for mug shape.
- Offset Mug to corner for handle direction if (holeCount == 1 || explicitly enabled)
- Add support for the weighted baseplate standard tire weights for people who don't want to use bolts/magnets
- Stabilize taper angle parameter
- Add attachment for airbrush cup directioning.
Changelog:
- 10/2/22: Increase resolution of exported 3mf
- 10/4/22:
- Change default parameters to match a small coffee mug
- Change mug handle guide to a petal design that better guides the mug into the groove
- Change mug guides to only go towards corners to improve grid compatibility.
- (v30) Fix mug base width parameter scaling
- 10/6/22:
- Change defaults to improve mug compatibility
- Update handle guide lofts to apply more consistently
- 10/7/22:
- Add picture and use case examples from personal setup
Tags
The author hasn't provided the model origin yet.