Get Free Shipping & Prusaments with the Prusa XL Summer Deal!

Mean Well SE-450-24 for BLV mgn cube

Bracket for attaching the Meanwell SE-450-24 to the BLV mgn cube. Attaches to the rear right corner. The idea behind…
1
17
0
157
updated September 30, 2022

Description

PDF

Bracket for attaching the Meanwell SE-450-24 to the BLV mgn cube. Attaches to the rear right corner.

The idea behind this design is to isolate all the mains voltage parts from the rest of the system. It is designed so there are no metal parts that are exposed both inside and outside of the case since that could cause them to become electrified if there is a cable loose on the inside. The exception is the PSU itself but that will be grounded.

To attach the IEC socket, insert two M3 nuts into the upper and lower slots there the socket inserts and then attach the socket with two M3 screws. The PSU itself attaches with M4 screws but be careful to not use ones that are too long! Check the datasheet for more information: https://www.meanwell.com/productPdf.aspx?i=463#1

The 24V wires are brought out of the case through the slots on the fan side of the case. There is one slot for each of the possible 24V connections.

The only place that needs support is the IEC opening but make sure to not stuff the nut slots with support material, it will be hard to get out. Otherwise, be careful with using to dense infill or too many layers, such a big print easily warps.

Category: 3D Printer Parts

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License