Dog Food Can Lid (1.2kg or 100mm diameter)

Avoid brittle PLA's for this, it needs some flex. Snaps on perfectly with this PLA+. Will be uploading another model without the splits for TPU/TPE for a water-tight fit.

Print settings (Cura):

Walls x 3

Top/Bottom x 6

.2mm layer height

4mm width

210c print

60 c bed

60mm/s

Flow 94% (gives me accurate measurements without any signs of under extrusion)

Coasting enabled 

Coasting Volume 0.032mm3 (helps remove the seem)

Fan 0% first layer to 100% at layer 3

No brim or skirt needed unless you have terrible bed adhesion. Add a brim or just slow down first layer. 

Print Settings

Printer:

Voxelab Aquila S2

Rafts: 

No

Supports:

No

Resolution: 

.2

Infill:

None

Filament:

eSun PLA+

Orange Post-Printing =============

Category: Containers