Per discussion at original page, I inverted the ruling lines so the gauge is now a single piece that can be printed without overhang problems.
Update: I added a lower-poly version which should produce a part of almost the same surface quality.
Update 5 May 2022: per reports from makers (see comments), I used Meshmixer to "true-up" the diagonal edge so that it properly crosses the center of a circular object. Use Rev3 now.
Printer:
anycubic vypger
Rafts:
Doesn't Matter
Supports:
No
Took the original gauge part into Meshmixer, made a solid copy and did a "boolean difference" with a rectangular solid to get the inverted scale lines. Combined the new part with the original, then merged with the second gaugeRev1.5 part.
Category: Hand ToolsThe author marked this model as their own original creation. Imported from Thingiverse.