Rasberry Pi Camera Bed Mount for Prusa MK2.5S (lengthened)

Based on jgeyer's mount, and made the following changes

1. Lengthened by 10mm to clear the angled print fan of MK2.5 and MK2.5S
2. Enlarge bottom hole where heat bed screw-head fit in, to avoid heat bed screw getting stuck during uninstallation.
3. Limited chamfer to 45 deg for no overhang
4. Adjusted mouth opening dimension to better fit the heatbed carrier frame, adjusted for overhang.

Print Settings

Supports:

No

Notes:

clear out holes using burr remover or knife.