Slim RC3 US with comfort features (plus shield)

Due to the need to print as many of these as possible, as quickly as possible, this is a remix of RC3 US version, that prints faster (and uses less filament). It still retains a measure of comfort because part of the band that sits on the forehead remains tall enough to provide large contact surface and provides stability. Faster printing comes down to the rest of the model being squished to minimal height that retains enough structural rigidity.

Unfortunately cannot be stacked. Still good for those that print during the day.

This is a derivative of https://www.prusaprinters.org/prints/27680-slim-rc3-with-comfort-features-plus-shield but using US dimensions for foil retainers.

• Includes variants with and without logos. Versions without logos squeeze out a few less minutes for print due to reduced head movements.

• Includes variants with integrated droplet shield that sits between forehead and foil holder (also with and without the logo). Suggested to print at 0.25 mm layer height to get 2 layers for the shield. Crosshatching ought to reduce porosity.

Print instructions

No supports required. Print at 0.25 mm layer height, 3 perimeters, 30% infill (same as official RC3, including PETG being preferred).