Ender Enclosure Pole Webcam Clip-On Tray

I wanted to use a Logitech Webcam I had on-hand for doing print time lapse recording in OctoPrint, but unfortunately it's mounting screw hole had broken completely out. So I created a small tray that clips on to the the support pole of the official Creality Ender enclosure that is just large enough for the webcam to sit on. Posting here in case anyone else might have a similar need.

Update 7/12/2021: I've noticed that the grip on the clip can loosen/slide a little when the printer enclosure is nice and warm. If you are considering printing this, you may want to mitigate the issue either by printing at a slightly smaller scale (I would guess 96-99% scale), using a more heat-resistant filament like PETG, or (what I did) simply putting a little masking tape around the pole just below the camera clip so it has no where to slide to.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

Rafts:

No

Supports:

No

Resolution:

200

Infill:

20

Filament: Ender Series PLA White