Eibos Easdry Skadis Holder

This holder allows placing your Eibos Easdry filament dryer on an IKEA Skadis pegboard.

⚠️ Be careful to not run the dryer when mounted on the wall, there were reports of overheating chamber. If you really want to, you could reverse the dryer with the fan hole facing you to make sure it's not running too hot.

It comes in two parts which are positioned on the left and right parts.

You can open the dryer and place/remove spools without completely unmounting it.

The cutouts on the sides are taller on purpose and they allow you to reverse the dryer and place it backward (facing the pegboard).

• Printed in PLA or PETG
• 0.2 mm
• 20% Infill
• With support