TS100 Case for NL-72W Power

Modified main box from original design to hold NL-72W power supply for the TS100 soldering iron.

Post-Printing

Assembly

Use the original lid for this remix box. 

The lid can be found here:   https://www.thingiverse.com/thing:2454180/files

The clips in the lid for the TS100 are the original clips (Klammer.stl).

Glue the small clips in the square indentations in the bottom of the box for holding solder tips.

(smallextended.stl) [these may need to be resized on your printer for proper fit and sizing]

5mmx3mm magnets were used on the box and lid.

Category: 3D Printing