Removable Door Hinge for Makerbot Replicator 2x

This can be a direct replacement for the stock hinges on a makerbot Replicator 2x, or be used to add a door to A Replicator 2 using the provided holes in the frame. It will fit the stock screws that car used on the rep 2x. 

The door can be removed by holding it at 90 degrees and sliding to the side. it cannot be slid out When the door is in the fully open or closed positions. 

There is enough angle that gravity will let the door sit open on it's own.

** Note: These hinges will not have the same tension on the door as the stock hinges so a clip or magnetic latch is reccomended for keeping the door fully closed and stable. 

-------------------------- 

***Optional:  There are thin slots on each section. If you remove the rare earth magnets from an old laptop hard drive and break it in half, you can insert each half in the slots to add additional hold when standing open. Secure the magnet in the slot with a bit of glue.