WALL PTFE TUBES HOLDER FOR MMU2S SETUP

Welcome to the MMU2S club! For those struggling to find a sweet way to place your filament rolls and PTFE tubes, I've made a little 3D part that may help you.

This part is to be used as attached to a wall (or any vertical surface), with the filament rolls being just above its position (40 to 60 cm). The part holds 5 festo fittings (that can be screwed in the bottom) that are aligned with 5 holes in the top part, where you need to feed your filament.

There are two different STL to download:

• sponged version, provided with a small wall that can use to put a sponge-like material on the top side (to perform filament dust cleaning)
• standard version, devoid of the sponge container wall

Happy printing!

3Diddy