Gardena Multi Connector

Easy to print Gardena compatible multi-connector with good water sealing.

The connectors are fitting tightly but are easy to connect/disconnect.

I only printed the 6 connectors version for a project.

The 4 connectors version is provided AS-IS and was not tested; it should just work though.

You have to add an O-ring for each connector otherwise this will leak.

Print Settings

Rafts:

No

Supports:

No

Resolution:

0.15

Infill:

25%

Filament: Prusa PC Blend Jet Black

Notes:

• printed upright like on the slicer's snapshot
10mm brim to increase the contact surface with the printing bed without support thanks to the circular shape of the middle pipe. Support might be needed depending on your printer and filament 5 wall perimeters to avoid water leaks in the infill