PhoneGrip

I needed a camera-style grip/stand for handheld video-recording, and I missed the good grip from my DSLR. 

Added 4x negative space 3 layers in, for 4 strong magnets (10x20x1) paused the pre print job as i put the magnets in, and I can mount the grip on my magnetic phone case,

one of the overhangs is a bit steep, but i did not need support for this print.

Printed in PLA, at 5,5% infill, only infill when necessary. I printed mine on a glas bed, with the flat part for attaching to phone-case faced down

I printed mine with a layer height of .28mm on on a .4mm nozzle, and it would most definitely be a lot prettier with a bit more patience and lower layer height.