Snap Latch Drill Bit Case

Video above will walk you through the assembly of my 3D printed snap latch drill bit case. This rugged Pelican style case only requires two different pieces of hardware and has been successfully snapping open and shut hundreds of times without failure. Bits are organized inside with a shelving system and do not mix when the case is tipped or shaken. 

If you are looking for the 99 piece drill bit set, take a look here: 

► https://amzn.to/3CaHJcM

Split pin sizes are 1/8" x 1-3/4" and 1/8" x 3/4"

► https://amzn.to/3LJS1DV

 ► https://amzn.to/3dOSO9P

 ► https://amzn.to/3Scn25C

As an Amazon associate I may earn a small commission (at no extra cost to you). 

Print the top and bottom cases at 0.2mm layer resolution and 20% infill. Latches can be printed at 0.2mm layer and 25%… they will likely get calculated as solid anyways. PLA+ for all parts will work fine. 

#3dprinting #tools #maker 

**************************************************************** 

If you enjoy and have benefited from my content and are feeling generous I would love your support! You can "buy me a coffee" here: 

► https://www.paypal.com/donate/?hosted_button_id=V2T6MEFUGP73Y

By supporting my channel you are encouraging me to continue with this time consuming endeavor. A lot of time goes into design work, building my projects, filming the videos, editing the videos, etc. Plus it all costs money! Your generosity goes a long way in helping me bring you better content as often as I can! 

Follow me on Instagram! 

► https://www.instagram.com/embracemaking/