GoPro Hero 8 Case

This case meets a few requirements:

• Have a flat spot on the bottom to stick some velcro
• Slide on and off, so I can take the GoPro out and attach it other ways while leaving the velcro stuck to the case.
• Allow access to the power and record buttons, the rear screen, and the side door

I've uploaded a version with an without a wider spot on the bottom for attaching 1" wide pieces (that's how wide the roll of 3M DualLock I use is).

Print on its side (pictured) to avoid long bridges. I printed in PETG and had to trim some, but the end result looks fine and is functional.