Do I need support to print this? for e.g: I tried printing "Z Post.3mf" but it fails everytime at the same layer height :(
MP3DP v4.1
V1 Engineering's CoreXY Printer
55
475
3
3968
updated
August 3, 2023
Makes
Comments
@RafaelMonteir_976257 No supports needed. It prints on it's side. Small part should have no issues.
Post some pictures in the v1e forums and we can help.
All parts printed in Overture Silk PLA using a much older Geeetech Aluminum prusa clone.
Added an enclosure to mine with a heated chamber using custom Octoprint plugin.
Printer is printing really well and is much faster than my older printer.
Might be a bit earlier than the 4.1, but pretty much the same printer, just a little larger, 250mm cubed build volume
@SupraGuy Thank you!!
I still have come clean up to do with the wire management and finding a proper home for the power supply, but it is assembled and working.
@Meaulnes did you have to upsize this to fit the ender 3 stuff? I'm looking at changing over my ender pro and wondered if it fits as is or if I need to upsize everything
@PrestonM_259559 I'm not entirely sure what you are asking here. I printed everything on a heavily modified Ender 5 Pro, and I did use a 235mm bed that I had initially bought as a replacement for the Ender 5. I did have to upsize everything to make the frame capable of holding that specific bed. @V1Engineering has directions about how to adjust the size in the forums, if not on the full on site.
View one more comment
Hey Ryan, noticed MP3DP license is different to the non-commercial you usually use for projects like MP LR3, intentional?
Looks like you used PLA. Do you recommend ABS if folks are planning to enclose MP 3DP and print higher temp filaments?
@AzaB2C All my projects other than the MPCNC and Lowrider are more "open". Thank you for checking.
Any filament can be used for this one. ASA seems like a better option these days than ABS, but I have not used either in a very long time.