Floating Phone Holder

Floating Phone Holder;,

This is a phone holder that is suspended by three sets of fishing line each side, the joins are invisable when twisted round into one of the holes. This is acutally supprisingly easy to build.

Shopping list:                                                  Print settings:

A 3D Printer(Obviously)                                 Infill; 5% (Triangular)

Some fishing line or thread                           Supports; Yes 

Epoxy glue (Or another appropriate glue)   Perimiters; 2

                                                                          Layer height; 0.30mm (Draft)

Assembly:

1. Print both of the parts; Base & Top
2. Gently remove supports and after they are removed remove any of the blmishes or imperfections they have left on the surface.
3. Put the parts in the position that they should be in and put the fishing line/thread through the holes and loosley through the holes evenly and after they are all the same tention tighen up all of them untill they resemble the pictures.
4. Once they are all perfecty tentioned dab a bit of epoxy glue onto the knot to seal it.
5. Once glue is dry move the knot into one of the holes in the phone holder.
6. And thats it youve got a functioning phone holder!

Happy Printing! Dont forget to post you makes and like the model! feel free to comment.

Print orientations

Top \/

Base \/