Romac+ (Romac Plus) Macropad Case

This is a simple drop-in case for the Romac+ macropad. 

It should with a tiny bit of wiggle room but fairly snug, unless you have overextrusion problems. Mine just barely brushes against the walls as it's dropped into the case.

The print is pretty fast even if you use 100% infill, which is what you see in the photos. I also paused twice for this print, to switch to translucent filament then back to black in order to achieve that “shine-through” glowing look for the RGB LEDs.

Print in photos created with:

• Ender 3 v2
• Tecbears Black and Transparent PLA
• 200 degree c nozzle
• 60 degree c bed
• glass bed
• 0.4 mm nozzle