B&T APC9 Pro Stand

This stand is made to work with the stock B&T magazines, also works with the aftermarket ones KCI makes.

The first version I made has the B&T logo cut in to the base
The second version uses a separate disc with the logo so you can use the stand facing either way

WARNING: When I print this on my Prusa MK3S+ the magazines are a tight fit and when I put them in and pull them out they do not seem to be scratching the magazines at all. If you want to print this but do not want a tight fit just increase the size slightly in your whatever slicer program you use. 

These were printed with Prusament PETG but you could use PLA
Print settings I use:

PETG
.2mm
15% infill
No supports needed