Nezuko Bamboo Cosplay/Costume

A simple model for the bamboo of Nezuko Kamado from Demon Slayer. My daughter is dressing up for Halloween and the one included with her costume was pretty bland. This has a cutout to make it comfortable and a hole to tie the red ribbon through.

I saw another version here as well, this version is smaller and is designed to not use a mouth piece as those were the preferences for my daughter.

Print stand up, I paint supports on the bottom section only. I've found it easiest to use smart selection to select the circle on the bottom, then use the brush to remove all but a small circle around the hole. This gives plenty of room to pull the supports off fairly eaisly.

I also print with a Brim maybe that's not necessary but this is a fairly low surface area print and relatively tall. I would recommend the brim for this.

Enjoy, maybe this helps someone else add a little more flare to their Halloween this year.