CR10 Smart Parts Cooling Duct (5015)

Remixed from PaulDrummond's parts cooling mod - note that his scr10 Smart hotend shroud is REQUIRED for this to attach properly.

This accommodates a 5015 blower fan, rather than the original design's intention of a 6010 fan. It should provide better performance.

V2 Lowers the entire module, allowing the air to hit the parts being printed better.

V3 Shaves a little off the bottom (it was a little close to the bed for my comfort) and corrects the fan holes' placements (they were a little off in V2). This version also removes a couple unneeded screw holes, reduces material needed, and reshapes the outlet.

V1 and V2 have been removed because they simply don't fit properly.

This is still in its beta state; I have yet to see how it performs.

Print Settings

Rafts:

Doesn't Matter

Supports:

Yes