Berkey Royal Water Stand

This is designed to raise the Berkey Royal Water Filter a little and let it sit over the lip of our kitchen sink.  This helps the spout to stick out over the sink a little more and be just high enough to make filling cups easier.  It also gets the spout just high enough to avoid a lot of our dish washing splashes.

This is my very first 3D model design.  I created this in Onshape and am also trying out Fusion 360 to see which program is easier for me to use.

I printed this at .28 layer height in PETG with 25% cubic infill.  15% or more infill should be enough but I wanted to make sure I could stand on it to prove to my wife it was strong enough to support a full Berkey without issue.   I used PETG to handle the occasional hot water or coffee spills that could happen around it.