Voron 2.4 Rear CANBUS Umbilical Mount IMPORTANT UPDATE

I am upgrading to a CAN setup on my Voron 2.4 and I needed Rear mount and Y endstop relocation bracket.  I remixed this excellent model intended for Huvud to better fit my needs.

IMPORTANT UPDATE No More Cable Gland, Could not overcome clearance issues.  Same with the Fan mount.

v13 - Taking it back old school… grumble No more cable gland.  Split body to make it easier to assemble.  Should snuggly hold a 10mm umbilical.  I may repost V10 with a bumper for Y clearance.

Check and recheck your clearances before homing!  I found out the hard way I had interference

*Side note not related to model.  If you are using EBB36 on a Galileo, you need a thinner Z chain for the same reason.  I ended up doing all umbilical.