Prusa Enclosure Flat LCD support
Flat LCD mount to have it stick out a little less.
9
43
0
496
actualizado
26 de septiembre de 2022
Descripción
PDFMade a flat LCD mount ‘cause our printers live in a not too wide corridor & I don’t want someone to bump into it & have it break.
To mount use a couple of M3x4 screws.
A thing to note is that the LCD is now the lowest point of the whole enclosure, so it can't stand on its own.
Etiquetas
Origen del modelo
El autor no ha proporcionado todavía el origen del modelo.