Original Prusa Enclosure Filament Passthrough

I needed to feed filament from my 3kg spool, so i have designed the passthrough port for the enclosure.
22m
1× print file
0.15 mm
0.40 mm
3.00 g
59
303
5
1826
updated September 19, 2022

Description

PDF

The bowden fitting is very firm, you might need to use players to push it in. If your print tolerances are a bit off. Use a 4mm drill to remove the excess from the print walls for the bowden fitting.

  • Print it flat with no support. 
  • Reuse the nylon rivets. 
  • You will need about 45 - 50 cm long bowden tube. 
  • print it as 0.15mm layer height it will take about 20 minutes. 

I have printed this in PLA however any other material can be used. 

Tags



Model origin

The author hasn't provided the model origin yet.

License