Moga Clip Z Fold 4 Standing Case Adaptor

Small block that goes into the Moga controller clips phone holder and then slots into the official Z Fold 4 standing case's accessory slot

Big thanks to ArthurBibik on thingiverse who released the blank module for the case slot that I used to make this work

I have no experience actually modeling stuff this was my first real attempt so I'm sure it could be improved (this is something like version 20)

There's some changes that could still be made but this good enough for me to use for the last 2 weeks with no issues so I'm just going to release it and move on

the block itself without the accessory blank is attached if anyone wants to try tweaking it

Its intentionally taller than the clips closed height so the springs can help hold onto it and its thickness is enough so that the outer screen doesn't touch anything even if bouncing around in a car. 

There's a smaller block for attaching the case blank so that the full block isn't scrapping against the phone case (I have a shallow scratch on my case as a result of earlier tests)

there's also some play in the holes for the grip arms, this is because there are likely to be some tolerance difference between printers and filaments that would make it more of a PITA for others, the top arms and lower arms are also in slightly different places on my clip and im unsure if that's a production issue or consistent between batches so i left it as a more generic locations for simplicity

PRINT SETTINGS - takes about 90 minutes from standby using my Prusa mini with bondtech extruder

.25 draft mode

Arachne for perimeter generator

3 perimeters (with the "use extra perimeters if needed option enabled) 

5% lightning infill

rest should be default settings for prusa mini

do note that increasing the perimeters will likely make the holes not line up right and probably fall out of the Moga clip

The version I've been testing was printed out of PLA and has been tossed around in my bag, and dropped a few times with no issues (also tried prying the case adaptor off with more than reasonable force and its still going strong)

***disclaimer i am not responsible for any damage caused to anything by your use of this file (be it phone, controller, clip. case, loss of job, or any other unlisted potential) 

 I have tested this only in my personal use case and while I have had no issues that does not mean you will not have any issues